Test Point 2

Fault code 02

NOTE: This fault can also be caused by incorrect operation (door lock actuated toward "closed" direction for longer than 60 seconds).

1. Pull off plug I on the alarm control module.
2. Disconnect plug connection X 11 (driver's side).
3. Disconnect the plug connection X 12 (passenger's side).
4. Check the leads from the alarm control module plug I pin 35 to the door lock modules for short to ground.
- Ohmmeter at alarm control module plug I pin 35 and ground
Display: Infinity Ohms

5. Check driver's side door lock module switch contact.
- Ohmmeter at plug connection X 11 pin A4 (sleeve side) and ground.
Door lock not actuated.
Display: Infinity Ohms

Door lock actuated towards "Closed".
Display: < 5 Ohms

6. Check passenger's side door lock module switch contact.
- Ohmmeter at plug connection X 12 pin A4 (sleeve side) and ground.
Door lock not actuated.
Display: Infinity Ohms

Door lock actuated towards "Closed".
Display: < 5 Ohms