Fault Code 0936

Fault code 0936

Passenger's power window switch

NOTE: This fault was detected by the 'passenger's door' control module.

Diagnostic conditions
- Ignition on
- Battery voltage OK (11.4 to 14.5 V)
- Internal function test on passenger's door control module

Possible causes of fault
- Short circuit to ground
- Switch for passenger's power window faulty

Affected pins
Passenger's door control module, plug A:
- Pin 4 'power windows button, local'
- Pin 19 'power windows button, terminal 31'

Diagnosis/troubleshooting

NOTE:
Visual inspection: In the next troubleshooting section, please check first that the affected pins on the passenger's door control module plug connection are neither damaged nor corroded. The wiring and plugs of the affected components must also be checked for external damage and correct contacts. Repair damaged or corroded pins if possible, otherwise replace affected pins. Repair or replace damaged wires.

NOTE:
Sporadic faults: In the event of faults that occur sporadically, the wiring positions that are linked to moving parts on and in the vehicle must be checked for each system. Various statuses that can cause faults must be simulated with the help of the wiring diagram.

NOTE:
Battery voltage: A battery voltage of between 11.4 and 14.5 V is required for the following troubleshooting procedure. This must be checked and provided, if necessary. On the vehicle electrical system, the voltage to the fuse (input side) must be guaranteed.

NOTE:
- 'Short circuit to ground' --> The fault is detected if there is ground potential for more than five minutes on plug A, pin 4.
- 'Implausible signal' --> This fault is detected if the resistance between pins 4 and 19 on plug A is between 360 and 470 Ohms.