Transfer Box (VG)

Fault Code 1312

CAN drive

Diagnostic conditions
- Ignition on
- Internal transfer box control module function test

Possible cause of fault
Communication problem with all control modules via CAN drive.
- CAN drive is faulty
- No signal/communication

Affected pins
Transfer box control module plug:
- Pin 11 'CAN drive (low)'
- Pin 42 'CAN drive (high)'

Diagnosis/troubleshooting VG 0101

NOTE: If there is no incoming signal/message via the CAN drive using several control modules, the CAN drive must be checked for open or short circuits. Refer to 'Checking instructions/CAN data bus'.