Fault code 0062

Fault code 0062

Level control function command

Diagnostic conditions
- Ignition on
- Internal control module function test
- Level control coded
- Output on the control module is active and the fault must occur at least three times before it is stored in the fault memory

NOTE: Activating the level control: The change in height adjustment/level control must be measured since the adjustment cannot be seen with the naked eye.

Possible causes of fault
- 'Short circuit to ground' No activation of level control.

Affected pins
Plug 'J' on vehicle electrical system control module:
- Pin 12 'output to activation signal for level control module'

Diagnosis/troubleshooting

NOTE:
- Before replacing the control module, the ground connections, power supply and plug connections on the control module must be checked.
- When replacing the vehicle electrical system control module, observe the coding of the control module.
- After the test drive, read out the fault memory with the 9588 Porsche System Tester II again. Additional causes of faults that could damage the vehicle electrical system control module should be detected and remedied.