P0562

P0562

System Voltage Low

Diagnostic conditions
- Speed > 25 km/h
- No "vehicle speed" fault recorded
- Time elapsed after start-up > 180 sec.

Possible cause of fault
- Vehicle electrical system control module malfunction
- Contact resistance in wiring
- Battery faulty
- Voltage regulator and alternator faulty

Affected terminals
DME control module connector A, pin 62 (terminal 30)
DME control module connector A, pin 3 (terminal 87)

NOTE: This fault is recorded if a supply voltage of less than 10 V is detected later than three minutes after the end of engine start-up.

Diagnosis/troubleshooting