P2088

P2088

Inlet Camshaft Output Stage, Bank 1 - Below Limit

Diagnostic conditions
- Battery voltage between 10 V and 16 V
- Time after engine starts: 10 seconds

Possible cause of fault
- Short circuit to ground in control line
- Magnetic hydraulic valve faulty (short circuit to casing)
- DME control module faulty

Affected pins
DME control module connector B, pin 115, and magnetic hydraulic valve connector, pin 2

Diagnosis/troubleshooting

NOTE: If fault P2088 is identified, the camshaft rises to its maximum advance angle.

NOTE: The wiring for fuse F9 and magnetic hydraulic valve connector, pin 1, is routed via the KE7 disconnection point, pin 6.