CD Changer: Service and Repair

WM 916019 Removing and installing CD changer

Technical values





Preliminary work

Information

- The CD changer is located behind the right rear side-panel lining.

Remove the side-panel lining at rear right. -> 700319 Removing and installing side-panel lining for rear luggage compartment - section on "removing" 700319 Removing and installing rear luggage compartment side-trim panel

Removing CD changer

WARNING

Risk of damage to audio system components

-> Remove ignition key and switch off the audio system.
-> Observe the requirements for working with optical waveguides. -> 97 General information on optical waveguides - MOST Bus

1. Unscrew the four fastening screws and pull out the carrier with CD changer & amplifier.





Unscrewing carrier fastening screws

2. Undo the six fastening screws, lift out the CD changer and pull forwards.





Unscrewing fastening screws for CD changer

3. Actuate detent -Arrow 1- -Arrow a- and disconnect plug.





Disconnecting optical waveguide

4. Unplug connector -Arrow 2-.

Installing CD changer

1. Position CD changer in the carrier and screw it down with the six fastening screws.=> Tightening torque: 4.5 ftlb.





Fastening screws for securing CD changer to carrier

2. Screw down the carrier with CD changer & amplifier. => Tightening torque: 6.5 ftlb.





Tightening carrier fastening screws

3. Insert plug -2- until it is felt to engage.





Inserting optical waveguide

4. Insert optical waveguide plug -1- until it is felt to engage.

Subsequent work

Install the side-panel lining at rear right. -> 700319 Removing and installing side-panel lining for rear luggage compartment - section on "installing" 700319 Removing and installing rear luggage compartment side-trim panel