691119 Removing and installing front three-point belt

WM 691119 Removing and installing front three-point belt

Tools





Preliminary work

1. Disconnect battery. -> 2706IN Working instructions after disconnecting the battery
2. Remove side trim panel.

General warning notes

Safety instructions for seat-belt pretensioner unit

DANGER

Removing and installing seat-belt tensioner unit.

- Danger of injury and damage to property as a result of incorrect handling of seat-belt tensioner units!

-> Always observe the safety regulations for handling seat-belt tensioner units. -> 691000 Safety regulations for airbag and seat-belt tensioner units
-> Disposal regulations for seat-belt tensioner units must be observed. -> 6900AW Disposal of airbag and seat-belt tensioner units
-> If removed for an extended period, the seat-belt tensioner unit must be kept in a secure location!
-> Remove ignition key. Disconnect battery. Route or isolate ground strap so that all contact with a ground carrier (e.g. body, seat frame) is avoided. -> 2706IN Work instructions after disconnecting the battery
-> After the battery is disconnected, always wait for 1 minute before disconnecting the seat-belt tensioner plugs.

Subsequent work

1. Install side-panel lining.
2. Connect the battery. -> 2706IN Working instructions after disconnecting the battery
3. Using the PIWIS Tester P 9718, read out the fault memory.