665019 Removing and installing rear logo

WM 665019 Removing and installing rear logo

Tools





Technical values





Removing rear logo

1. Heat the rear lid
1.1. Heat the rear lid -1- in the area of the logo -2- using the hot-air gun v.a.g 1416 -3-.





Heating logo

2. Lifting up the logo using a plastic wedge
2.1. Move a plastic spatula -1- under the logo -2- and lift it up.





Lifting up logo

3. Clean the cover
3.1. Loosen the adhesive residue -1- on the cover -2- using a silicone remover and remove it.





Cleaning the cover

Replacing model logo

Replacing Boxster model logo

1. Find the centre of the lid.





Boxster logo

2. Position logo -Boxster- on the lid with the dimensions -A, B- => Gap dimension: 140.3 mm+/-1 mm and -C- => Gap dimension: 55.9 mm+/-1 mm and stick it on.

Replacing Boxster S model logo

1. Find the centre of the lid.





Boxster S logo

2. Position logo -Boxster S- on the lid with the dimensions -A - => Gap dimension: 174.1 mm+/-1 mm and -C- => Gap dimension: 55.9 mm+/-1 mm and stick it on.
3. Position logo -S- on the rear lid with the dimensions -B- => Gap dimension : 174.1 mm+/-1 mm and -D- => Gap dimension: 50.4 mm+/-1 mm and stick it on.