Door/Trunk Ajar Indicator/Lamp: Service and Repair

WM 961619 Removing and installing door warning light

Removing bulb for door warning light

Removing door warning light

CAUTION

Danger of damage to property if bulbs are used or handled incorrectly!

- Risk of damage to bulbs and bulb housing.

-> Switch off ignition and remove ignition key.
-> To prevent short circuits, the load in question must be switched off while changing bulbs.
-> Only bulbs specified in the bulb table may be used.
-> Bulbs with a higher wattage may damage the bulb housing.
-> New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands. Use a cloth or soft paper when changing bulbs.
-> In certain states, it is compulsory to carry spare light bulbs.





Overview of door warning light, shown on the 911





1. Push door warning light carefully out of the door trim via the cutaway -arrow- using a screwdriver.





Removing door warning light

2. Pull off door warning light connector and remove light.

Removing bulb for door warning light

1. Remove bulb socket from the door warning light and remove defective bulb.





Removing bulb for door warning light

Installing bulb for door warning light

Information

Only use the relevant bulb specified in the bulb table => IN - Bulb table and installation instructions - "Information".

1. Insert new bulb in the bulb socket and insert the socket into the door warning light opening.





Installing bulb for door warning light

Installing door warning light





Overview of door warning light, shown on the 911

1. Push connector on to door warning light.





Installing door warning light

2. Press door warning light into door trim panel.