912419 Removing and installing car radio

WM 912419 Removing and installing car radio

Tools





Technical values





Preliminary work

1. If a new control unit has to be installed, the values/coding must be read out using the 2nd generation PIWIS Tester 9818 prior to removing the "old" control unit. -> 912455 Replacing car radio 912455 Replacing car radio.
2. Remove the two air vents at the car radio. -> 855319 Removing and installing centre air vent - section on "Removing" 855319 Removing and installing centre air vent

Removing car radio





Installation position of car radio

1. Switch off ignition and remove remote control.
2. Unscrew the four fastening screws -1- and pull out the car radio.





Unscrewing fastening screws

3. Release the securing clip -2- for the electric plug connection -3- by lifting the locking lug -a-.





Releasing and unplugging electric plug connection

4. Release the electric plug connection by opening -arrow B- the securing clip and unplug it.
5. Release the electric plug connection -4- ( -b- ) and unplug it.





Unplugging electric plug connection

Installing car radio

1. Press in the electric plug connection -4- until the connector engages securely.





Connecting electric plug connection

2. Place the electric plug connection -3- onto the car radio and lock the plug connection by closing -arrow C- the securing clip -2-. Make sure that the locking lug latches into place -a-.





Plugging in and locking electric plug connection

3. Insert the car radio into the mounting.
3.1. Insert the car radio as far as it will go -arrow-.
3.2. Make sure that the lines are not pinched.
4. Position the four fastening screws -1- and tighten.=> Tightening torque: 7 Nm (5 ftlb.)





Tightening fastening screws

Subsequent work

1. If the control unit was replaced, the "new" control unit must be adapted to suit the vehicle using the 2nd generation PIWIS Tester 9818. -> 912455 Replacing car radio 912455 Replacing car radio.
2. Install the two air vents at the car radio. -> 855319 Removing and installing centre air vent - section on "Installing" 855319 Removing and installing centre air vent