Front Fender Liner: Service and Repair

WM 505619 Removing and installing front wheel housing liner

Technical values





Preliminary work

1. Remove front wheel. => 440519 Removing and installing wheel - section on "Removing"

Removing front wheel housing liner

Removing front wheel housing liner - rear section





Installation position of front wheel housing liner

Information

Fastening nuts cannot be used again following removal.

1. Unscrew fastening nuts -1- and fastening screws -2-.





Removing front wheel housing liner - rear section

2. Remove wheel housing liner -A-.

Remove front wheel housing liner - front section

1. Unscrew fastening screws -2, 3- and remove the front section of the front wheel housing liner -B-.





Removing front wheel housing liner - front section

Installing front wheel housing liner

Install front wheel housing liner - front section

1. Insert front section of front wheel housing liner -B-.





Installing front wheel housing liner - front section

2. Tighten fastening screws -2-. => Tightening torque: 2.8 Nm (2 ftlb.)
3. Tighten fastening screws -3-. => Tightening torque: 2.8 Nm (2 ftlb.)

Installing front wheel housing liner - rear section

Information

- Push in wheel housing liner toward the outside up to contact in wing stop position.

- Ensure that the right wheel housing liner is guided through the opening on the wheel well.

1. Insert wheel housing liner -A-.





Removing front wheel housing liner - rear section

2. Tighten fastening nuts -1-. => Tightening torque: 2.5 Nm (2 ftlb.).
3. Tighten fastening screws -2-. => Tightening torque: 2.8 Nm (2 ftlb.).

Subsequent work

1. Fit front wheel. => 440519 Removing and installing wheel - section on "Installing"