611019 Removing and installing front convertible-top mount
WM 611019 Removing and installing front convertible-top mount
Technical values
Preliminary work
1. Move convertible top to service position. => 6101IN IN - convertible top service position
Information
Only for vehicles with hardtop.
2. Remove hardtop. => 610219 Removing and installing hardtop - section on "Removing"
Preliminary work
Information
Only for removing/installing or replacing convertible-top peg mount.
1. Remove sun visor. => 682319 Removing and installing sun visor - section on "Removing"
Removing front convertible-top mount
Removing centering journal
Installation location of front mount
1. Unscrew fastening screws -1- and remove centering journal -2-.
Removing centering journal
Removing centering journal (hardtop)
Installation location of front mount
1. Unscrew fastening screws -1- and remove centering journal -2- with support -2A-.
Removing centering journal
Removing convertible-top peg mount
Installation position of convertible-top peg mount
1. Unclip cap -1- in a downward direction with a small screwdriver and remove it -arrow A-.
Removing convertible-top peg mount
2. Unscrew fastening screws -2- and remove convertible-top peg mount -3- downwards -arrow B-.
Installing front convertible-top mount
Installing centering journal
Installation location of front mount
1. Position centering journal -2- on convertible top frame -3- and screw down the fastening screws -1-. Tightening torque => Tightening torque: 10 Nm (7.5 ftlb.)
Installing centering journal
Installing centering journal (hardtop)
Installation location of front mount
1. Position centering journal -2- with support -2A- on the hardtop body -3- and screw down fastening screws -1-. Tightening torque => Tightening torque: 10 Nm (7.5 ftlb.)
Installing centering journal
Installing convertible-top peg mount
Installation position of convertible-top peg mount
1. Place convertible-top peg mount -1- on windscreen frame from below -arrow A- , position it correctly and screw down hand-tight using the fastening screws -2-.
Installing convertible-top peg mount
2. To position convertible-top peg mount, close convertible top or fit hardtop.
3. Move convertible-top peg mount as far as possible outwards (towards the centering journal) -arrow B- and screw down. Tightening torque => Tightening torque: 10 Nm (7.5 ftlb.)
4. Position cap -3- from below -arrow C- and clip into place.
Subsequent work
1. End service position. => 6101IN IN -Convertible top in service position
2. Check gap dimensions for convertible top, adjust if necessary.=> 501000 Diagram - body gap dimensions
Information
Only for vehicles with hardtop.
3. Install hardtop. => 610219 Removing and installing hardtop - section on "Installing"
Information
Only for vehicles with hardtop.
4. Adjust hardtop. => 610215 Adjusting hardtop - section on "Adjusting"
Subsequent work
Information
Only for removing/installing or replacing convertible-top peg mount.
1. Install sun visor. => 682319 Removing and installing rear window - section on "Installing"