Wiper Motor Linkage: Service and Repair

WM 921919 Removing and installing wiper link

Technical values





Preliminary work

Preliminary work on wiper motor

Disconnect the battery and cover terminal or battery. => 271000 Work instructions after disconnecting the battery

Left plenum chamber cover => 852219 Removing and installing cover - section on "Removing"

Preliminary work for wiper linkage

Remove wiper arms. => 924119 Removing and installing wiper arm for rear window wiper system - section on "Removing"

Remove cowl panel cover. => 508719 Removing and installing cowl panel cover - section on "Removing"

Disconnect the battery. => 2X00IN02 Work instructions after disconnecting the battery

Removing wiper link

1. Unscrew the three fastening screws -3- for the wiper linkage and release and unplug the electric connector for the wiper motor.





Unscrewing fastening screws

2. Remove wiper linkage. If the wiper motor must be removed from the wiper linkage, then proceed according to "Removing and installing wiper motor"=> 921519 Removing and installing wiper motor - section on "Removing".

Installing wiper link

1. If necessary, fit the wiper motor to the wiper linkage. => 921519 Removing and installing wiper motor - section on "Installing"
2. Position wiper linkage in the radiator tank and screw down the fastening screws -3A, 3B, 3,C- in turn. => Tightening torque: 10 Nm (7.5 ftlb.)





Tightening sequence

Subsequent work

Reworking wiper link

=> 508719 Removing and installing cowl panel cover - section on "Installing"

Left plenum chamber cover => 852219 Removing and installing cover - section on "Installing"

=> 922519 Removing and installing wiper arm - section on "installing"

Connect battery. => 271000 Work instructions after disconnecting the battery