741919 Removing and installing cover for front backrest
WM 741919 Removing and installing cover for front backrest
Preliminary work
Information
The air cushions and lumbar support must be deflated before removing the front seat.
1. Remove front seat. -> 720119 Removing and installing front seat - section on "Removing" 720119 Removing and Installing Front Seat
2. Position front seat on assembly fixture.
Front seat on assembly fixture
3. Remove cover for front centre backrest. -> 742019 Removing and installing cover for front centre backrest - section on "Removing" 742019 Removing and installing cover for front middle backrest
Removing cover for front backrest
Removing guide for seat belt
1. Remove guide for seat belt -1- at top -Arrow A-.
Loosening guide for seat belt at top
2. Unscrew fastening screw -2- and remove push button -3- -Arrow B-.
3. Press out cap -2- and unscrew fastening screw -3- with spacer -4-.
Loosening guide for seat belt at bottom
4. Remove guide for seat belt -1- and sleeve -5-.
Removing cover for front backrest
Installation position of cover for front backrest
1. Press out cover for backrest -1- from the backrest shell -2- lower left and right using a screwdriver -3-.
Disengaging cover for backrest
2. Slightly loosen cover for backrest -1- at outside of backrest shell -2- , starting from the bottom with a screwdriver -3- , and pull out all around by hand.
Disengaging cover for backrest
3. Press out cover piping -1- right and left from backrest frame -2-.
Loosening cover piping
4. Push out plastic strip -2- on cover for backrest -1- from the fixing clips -3- in direction of arrow -A, B, C-.
Loosening cover for backrest
5. Remove cover for backrest -1-.
Installing cover for front backrest
Installing cover for backrest
Installation position of cover for front backrest
1. Fit cover for backrest and align with contour of padding.
2. Check fastening clips -3- , and replace if necessary.
Fastening cover for backrest
3. Press plastic strip -2- on cover for backrest -1- into the fixing clips -3-.
4. Engage cover piping -1- right and left into backrest frame -2-.
Fastening cover piping
5. Press connection of backrest cover -1- sideways into the backrest frame -2- with a plastic wedge -3-.
Fastening cover for backrest at sides
6. Press cover for backrest -1- into the backrest shell -2- lower left and right using a screwdriver -3-.
Fastening cover for backrest at bottom
Installing guide for seat belt
Information
If the backrest cover -1- has been replaced after repairs, the seat-belt guide mounting points must be measured again and marked.
Marking seat-belt guide mounting points
- Mark upper mounting point with the dimensions -A= 95 mm- and -B= 50 mm-.
- Mark lower mounting point with the dimensions -C= 25 mm- and -D= 155 mm-.
1. Position seat-belt guide -1- with sleeve -5- with the aid of the marking on the backrest cover.
Fastening guide for seat belt at bottom
2. Tighten fastening screw -3- with spacer -4-.
3. Press in -2- cap
4. Position push button -3- with the aid of the marking on the backrest cover -Arrow A- and screw down with the fastening screw -2-.
Fastening guide for seat belt at top
5. Press seat-belt guide -1- into push button -3- at top -Arrow B-.
Subsequent work
1. Install cover for front centre backrest. -> 742019 Removing and installing cover for front centre backrest - section on "Installing" 742019 Removing and installing cover for front middle backrest
2. Install front seat. -> 720119 Removing and installing front seat - section on "Installing" 720119 Removing and Installing Front Seat