970955 Replacing sub-part of wire harness in engine compartment at the left

WM 970955 Replacing sub-part of wire harness in engine compartment at the left

Tools





Information

The main wire harness is manufactured individually depending on equipment.
- Fastening elements may be different from the parts described.
- The number of plug connections can vary, depending on equipment.

Preliminary work

1. Loosen main wire harness in engine compartment at the left. -> 970909 Loosening and securing main wire harness in engine compartment at the left - section on "Loosening" 970909 Loosening and securing main wire harness in engine compartment at the left
2. Remove dashboard bracket. -> 516819 Removing and installing dashboard bracket - section on "Removing" 516819 Removing and Installing Dashboard Support

Replacing wire harness in engine compartment at the left





Overview of main wire harness in engine compartment at the left





1. Loosen the wire harness -1- from the rubber sleeve to the engine compartment -2- as far as the centre of the vehicle.





Releasing wire harness

Information

When cutting the front wire harness, make sure there is enough length of cable left to join to the new lines.

2. Cut the strands of the engine compartment wire harness at the left in area -X-.





Connection point area

3. Press rubber sleeve -1- through towards the engine compartment -A- and pull the wire harness -2- into the engine compartment -A-.





Removing wire harness in engine compartment at the left

4. Pull the wire harness -2- through from the engine compartment into the passenger compartment -A- and fit the rubber sleeve -1- at the correct position.





Pulling in wire harness in engine compartment at the left

Information

Select a place for the joint where there is enough space to join all the lines present.

Do not cut the lines too short in case they have to be laid in a different position if there is insufficient space in the area of the joint.

Information

The greatest care must be used in the individual work steps for stripping insulation from, crimping, and shrinking/insulating the electric lines.

The procedure for stripping insulation from, crimping, and shrinking/insulating the electric lines must be complied with and observed. The procedures are described in detail in the Repair kit for Cayenne wire harnesses NR.155-2.

Crimping samples must be prepared before beginning work.

Information

Allocation of lines - see wiring diagram.

5. Crimp the lines in area -X-.





Connection point area

6. Secure the wire harness -1- from the rubber sleeve to the engine compartment -2- as far as the centre of the vehicle.





Securing wire harness

Subsequent work

1. Secure main wire harness in engine compartment at the left. -> 970909 Loosening and securing main wire harness in engine compartment at the left - section on "Securing" 970909 Loosening and securing main wire harness in engine compartment at the left
2. Install dashboard bracket. -> 516819 Removing and installing dashboard bracket - section on "Installing" 516819 Removing and Installing Dashboard Support