971619 Removing and installing front wire harness

WM 971619 Removing and installing front wire harness

Preliminary work

Remove lock support. -> 503819 Removing and installing lock support - section on "Removing" Service and Repair

Removing front wire harness

NOTICE

Voltage peaks

- Risk of damage to load or to the control unit

-> Switch off ignition and remove remote control before disconnecting or removing load.





Installation position of front wire harness

1. Release electrical plug connection for airbag sensor -1- ( -a- ) and pull it off -A-.





Removing ABS sensor plug connection

2. Unclip clips -3- on the side -A- using a screwdriver.





Front wire harness clips

3. Unclip clips -2- ( -B- ).

Installing front wire harness

1. Clip in clips -2- at the lock support -B-.





Wire routing

2. Clip in clips -3- at the lock support -A-.
3. Insert electrical plug connection for airbag sensor -1- ( -A- ) and lock it -a-.





Installing ABS sensor plug connection

Subsequent work

Install lock support. -> 503819 Removing and installing lock support - section on "Installing" Service and Repair