Operation CHARM: Car repair manuals for everyone.

Sunroof / Moonroof Interior Trim Panel: Service and Repair


WM 604019 Removing and installing sliding-roof panel

Technical values





Technical values

Gap dimensions of sunroof

=> Gap dimension: 1 mm-1 mm





Roof to sliding-roof panel
=> Gap dimension: 0.8 mm+0.2 mm-0.8 mm





Sliding-roof panel to roof


Removing sliding-roof panel

Information

Some of the repair illustrations show only one side of the vehicle. Naturally, some steps also have to be performed on the opposite side of the vehicle as well. These must be carried out as a mirror image of the steps shown.

1. Raise the sliding roof fully.
2. Remove the bellows.





Removing bellows

2.1. Unclip the bellows from the panel -A-.
2.2. Slide the bellows forward slightly -B- and unclip it from the upper rear catch -1-.
2.3. Unclip the bellows from the lower edge -C-.
3. Remove sliding-roof panel.





Removing sliding-roof panel

3.1. Loosen the centre fastening screw -2-.
3.2. Unscrew front and rear fastening screws -3-.
4. Lift the panel up and remove it.

Installing sliding-roof panel

Information

Some of the repair illustrations show only one side of the vehicle. Naturally, some steps also have to be performed on the opposite side of the vehicle as well. These must be carried out as a mirror image of the steps shown.

1. Position the panel and guide the clips into the drive mechanism.
2. Install sliding-roof panel.





Installing sliding-roof panel

Use new screws during installation: => SET
2.1. Screw in front and rear fastening screws -3- and adjust gap dimensions.
When positioning the panel, check that there is an equal gap between the panel and roof cut-out. Align the panel in the longitudinal and transverse direction if necessary.
2.2. Tighten all fastening screws -2, 3- to => Tightening torque: 4.5 Nm (3 ftlb.).
3. Install the bellows.





Installing bellows

3.1. Clip the bellows into the upper rear catch -1- ( -A- ).
3.2. Clip in the bellows on the panel -B-.
3.3. Clip the bellows onto the lower edge -C-.
4. Teach the end position. -> 6006AN Teaching roof systems 6006AN Teaching roof systems