978409 Loosening and securing fuse box
WM 978409 Loosening and securing fuse box
Preliminary work
Preliminary work for loosening front left fuse box
1. Disconnect battery ground strap. -> 2X00IN Work instructions after disconnecting the battery - section on "Disconnecting" 2X00IN Work instructions after disconnecting the battery
2. Remove trim panel under dashboard. -> 701919 Removing and installing trim panel under dashboard - section on "Removing" 701919 Removing and installing trim panel under dashboard
Preliminary work for loosening front right fuse box
1. Disconnect battery ground strap. -> 2X00IN Work instructions after disconnecting the battery - section on "Disconnecting" 2X00IN Work instructions after disconnecting the battery
2. Remove glove box. -> 681519 Removing and installing glove box - section on "Removing" 681519 Removing and installing glove box
Preliminary work for loosening rear fuse box
Disconnect battery ground strap. -> 2X00IN Work instructions after disconnecting the battery - section on "Disconnecting" 2X00IN Work instructions after disconnecting the battery
Information
Component information
Installation position of fuse box
Loosening fuse box
Loosening fuse box at front left and right
NOTICE
Voltage peaks
- Risk of damage to loads or to the control unit
-> Disconnect the battery before removing the component or control unit.
1. Switch off ignition and remove remote control.
2. Unscrew the two fastening screws -2- on the fuse box.
Unscrewing fastening screws
3. Press the fuse box inward -arrow A- and leave it hanging at the connections.
Loosening rear fuse box
NOTICE
Voltage peaks
- Risk of damage to loads or to the control unit
-> Disconnect the battery before removing the component or control unit.
1. Switch off ignition and remove remote control.
2. Unscrew the two fastening screws -1- on the fuse box.
Unscrewing fastening screws
3. Pull the fuse box up out of the guide and set it aside.
Removing fuse box from the guide
Securing fuse box
Securing fuse box at front left and right
1. Position the fuse boxes from inside.
2. Tighten the two fastening screws -2- on the fuse box.
Tightening fastening screws
Tightening rear fuse box
1. Slide the fuse box into the guide from above.
Sliding in fuse box
2. Tighten the two fastening screws -1- on the fuse box.
Tightening fastening screws
Subsequent work
Subsequent work for securing front left fuse box
1. Install trim panel under dashboard. -> 701919 Removing and installing trim panel under dashboard - section on "Installing" 701919 Removing and installing trim panel under dashboard
2. Connect battery ground strap. -> 2X00IN Work instructions after disconnecting the battery - section on "Connecting" 2X00IN Work instructions after disconnecting the battery
Subsequent work for securing front right fuse box
1. Install glove box. -> 681519 Removing and installing glove box - section on "Installing" 681519 Removing and installing glove box
2. Connect battery ground strap. -> 2X00IN Work instructions after disconnecting the battery - section on "Connecting" 2X00IN Work instructions after disconnecting the battery
Subsequent work for securing rear fuse box
Connect battery ground strap. -> 2X00IN Work instructions after disconnecting the battery - section on "Connecting" 2X00IN Work instructions after disconnecting the battery