669655 Replacing trailer hitch control unit

WM 669655 Replacing trailer hitch control unit

Tools





Technical values





Reading and writing values

NOTICE

Voltage drop

- Risk of irreparable damage to control unit
- Risk of damage to control unit
- Fault entries in the control unit
- Coding in the control unit is aborted
- Malfunctions in control unit, even during programming

-> Prior to disconnecting the control unit, switch off the ignition and remove the ignition key.
-> Ensure that the power supply is not interrupted during programming.
-> Connect a battery charger with a current rating of at least => Nominal value: 40 A to the vehicle battery.

Information

The PIWIS Tester II 9818 instructions take precedence since the description may be different with later Tester releases.

The procedure described here has been structured in general terms. Different text or additional information may appear in PIWIS Tester II 9818.

1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch on ignition and press F12 to continue.
2. Select vehicle type.
3. Select the required control unit, e.g. Trailer hitch in the overview.
4. Select Maintenance/repairs.
5. Select Control unit replacement and press F12.
6. Select Read data and press F12.
7. Press F8 to start reading out data.
8. Check the chassis number and press F12.
9. Switch off ignition and replace control unit. -> 669619 Removing and installing trailer hitch control unit 669619 Removing and installing trailer hitch control unit.
10. Switch on ignition. Select the Write data menu (procedure described above), press F12 and then press F8 to start installing the data that was read out.
11. The System Tester displays the message Data has been written. Press F12 to continue.
12. Fault memory must be selected and erased if necessary.