Shifter A/T: Adjustments

SELECTOR LEVER AND GEAR INDICATION

Removing/Adjusting





1 Undo the two screws on the front of the selector lever and lift the handle from the rod.

2 Set the selector lever to position 1.

3 Undo the screw and remove the gear indicator cover.

4 Remove the centre console.

5 Undo the screw securing the air duct and lift it up slightly.

6 Undo the four screws securing the selector lever bracket and move the bracket forwards or back-wards.

7 Refit the gear indicator cover and check the position in the opening in the cover. Check that gear indication is correct and that there is play in positions P and 1.

8 Check selector cable adjustment in positions N and D. Play should be the same in both positions.

Fitting

Refit in reverse order.

Left-hand drive cars:
The plastic spacer which angles the selector lever towards the driver should be fitted on the right-hand side.

Right-hand drive cars:
The plastic spacer which angles the selector lever towards the driver should be fitted on the left-hand side.