Brake Fluid Level Sensor/Switch: Service and Repair

Brake Fluid Level Indicator Switch Replacement

Removal Procedure




1. Disconnect the electrical connector from the fluid level sensor.





Important: When performing the following service procedure, it is NOT necessary to drain the master cylinder reservoir.


2. Using pair of needle nose pliers, compress the locking tabs for the fluid sensor located at the opposite side of the master cylinder.




3. Remove the fluid level sensor from the master cylinder reservoir.

Installation Procedure





Important: Ensure that the fluid sensor is fully seated before releasing the snap ring.


1. Install the fluid level sensor.




2. Install the electrical connector to the fluid level sensor.