Antenna Cable Replacement (Coupe)

Antenna Cable Replacement (Coupe)

Special Tools

KM6067 Radio Removal Tools

Removal Procedure

Note: Replace or repair wiring harnesses observing the safety regulations of electrics/electronics.

Warning: Refer to Battery Disconnect Warning (Service Precautions).

1. Disconnect the battery.




2. Remove the radio.

* Install the removal bar KM6067 into the openings (arrows) until it engages.
* Pull both removal bars outwards and at the same time withdraw the radio from the holder.

3. Disconnect the wiring harness plug.
Disconnect the 2 wiring harness plugs (1, 2).




4. Remove the instrument panel (I/P) compartment.

* Open the I/P compartment door.
* Remove the 4 bolts (1).
* Disconnect the wiring harness plug.
* Remove the I/P compartment.




5. Remove the door sill inner panel.

* Release the 5 clips.
* Remove the sill inner panel (1).

6. Lower the headlining trim panel. Refer to Headlining Trim Panel Replacement (Sedan) (Service and Repair)Headlining Trim Panel Replacement (With Sunroof) (Service and Repair)Headlining Trim Panel Replacement (Coupe) (Service and Repair).
7. Remove the rear compartment side trim panel. Refer to Rear Compartment Side Trim Panel Replacement (Coupe) (Service and Repair)Rear Compartment Side Trim Panel Replacement (Sedan) (Service and Repair).




8. Disconnect the roof antenna wiring harness plug (1).




9. Disconnect the antenna cable (1) and insulate the remaining ends.





Note:
* The old antenna cable remains in the wiring harness.
* The new antenna cable is routed parallel to the existing antenna cable and is secured with duct tape and cable ties.

10. Route the antenna cable up to behind the I/P compartment.




11. Disconnect the antenna cable from I/P padding wiring harness.
Disconnect and insulate the wiring harness (1).

Installation Procedure

1. Connect the wiring harness plug of the roof aerial.
2. Install headlining trim panel. Refer to Headlining Trim Panel Replacement (Sedan) (Service and Repair)Headlining Trim Panel Replacement (With Sunroof) (Service and Repair)Headlining Trim Panel Replacement (Coupe) (Service and Repair).
3. Remove the rear compartment side trim panel. Refer to Rear Compartment Side Trim Panel Replacement (Coupe) (Service and Repair)Rear Compartment Side Trim Panel Replacement (Sedan) (Service and Repair).
4. Install the radio.

* Connect the 2 wiring harness plugs.
* Push the radio into the holder until it engages.

5. Install the I/P compartment.
Connect the wiring harness plug.

Caution: Refer to Fastener Caution (Fastener Caution).

6. Install the I/P compartment.

Tighten the 4 screws to 4 Nm (35 lb in).
Close the I/P compartment door.
7. Install the door sill inner panel.
Clip in the 5 clips.
8. Connect the battery.
9. For reprogramming procedures, refer to Control Module References (Programming and Relearning).