Shifter A/T: Adjustments

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: ADJUSTMENT; 2013 MY FR-S [03/2012 -]

1. REMOVE FRONT EXHAUST PIPE ASSEMBLY

Removal

2. ADJUST SHIFT LEVER POSITION

(a) While pushing the shift lock release button, move the shift lever to N.

(b) Using tape, hold a 0.3 mm feeler gauge on the floor shift control select lever.





(c) Using tape, attach the floor shift control select lever to the console box assembly.





NOTICE:
Make sure that the feeler gauge is not on the area shown in the illustration.

(d) Remove the nut and disconnect the floor shift gear shifting rod sub-assembly.





(e) Turn the transmission control shaft lever RH of the park/neutral position switch assembly counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.





(f) Temporarily install the floor shift gear shifting rod sub-assembly with the nut.





(g) Tighten the nut while lightly pushing the lever rearward.

Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)

NOTICE:
Do not push the lever too hard.

3. INSTALL FRONT EXHAUST PIPE ASSEMBLY

Installation

4. INSPECT SHIFT LEVER POSITION Initial Inspection and Diagnostic Overview

5. INSPECT FOR EXHAUST GAS LEAK