Countershaft: Service and Repair

COUNTERSHAFT BEARINGS

REMOVAL





1. Remove snap rings by using a screwdriver.
2. Remove backing plate (rear cover side).





3. Remove front and rear counter shaft bearings, as follows:
a. Using special tools (Bearing remover and sliding shaft), remove bearing.
b. Remove other side of bearing in the same way.
Special Tool:
(A): 09941 -64511 or equivalent.
(B): 09930-30102 or equivalent.

INSTALLATION





1. Install countershaft bearing (Roller bearing) to case. Use special tools (Bearing installer attachment and installer handle). The bearing installer attachment has two sides. Use small side A for installation of countershaft bearings.
Special Tool:
(A): 09924-74510 or equivalent.
(B): 09926-88310 or equivalent.
2. Install snap ring.





3. Install countershaft spacer to case.
4. Install another countershaft bearing (ball bearing) to case. Use special tools (Bearing installer attachment and installer handle).
5. Install bearing backing plate and snap ring.