P0707

DTC P0707 (No.34): Transmission Range Sensor Circuit Low Input





Wiring Diagram

DTC Detecting Condition and Trouble Area
DTC detecting condition
Transmission range switch signal (P, R, N, D, 2 or L) is not inputted for more than 25 seconds at more than 60 km/h (35 mile/h) vehicle speed.
Trouble area
^ Select cable maladjusted,
^ Transmission range sensor (switch) maladjusted.
^ Transmission range sensor (switch) or its circuit.
^ TCM

DTC Confirmation Procedure

WARNING:
^ When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
^ Road test should be carried out with 2 persons, a driver and tester, on a level road.

1. Connect scan tool to DLC with ignition switch OFF.
2. Clear DTCs in TCM and ECM memories by using scan tool and start engine.
3. Start vehicle and increase vehicle speed to about 70 km/h (44 mile/in) in both "D" and "2" range.
4. Keep driving the vehicle speed for 20 seconds.
5. Release accelerator pedal, decrease vehicle speed and stop vehicle.
6. Turn ignition switch OFF.
7. Repeat Step 4 to 6 one time.
8. Check DTC, pending DTC and freeze frame data.

Part 1 Of 2:

Part 2 Of 2:

DTC Troubleshooting