P2025

DTC P2025: EVAP Fuel Vapor Temp. Sensor Performance

Wiring Diagram:

Wiring Diagram

DTC Detecting Condition:

DTC Detecting Condition and Trouble Area

DTC Confirmation Procedure

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and tester, on a level road.

NOTE: Check that the following conditions are satisfied when using this DTC Confirmation Procedure.
- Engine coolant temp. at engine start: less than 40 °C (104 °F)
- Intake air temp.: between 10 °C and 35 °C (14 °F and 95 °F)
- Altitude (barometric pressure): 2500 m, 8202 ft or less (560 mmHg, 75 kPa or more)

1. With ignition switch turned OFF, connect scan tool.
2. Turn ON ignition switch and clear DTC using scan tool.
3. Start engine and warm up to normal operating temperature.
4. Drive vehicle at 40 mph (65 km/h) or more for 5 min.
5. Check DTC and pending DTC.

Step 1 - 4:

Step 5 - 8:

DTC Troubleshooting

WARNING: In order to reduce risk of fire and personal injury, this work must be performed in a well ventilated area and away from any open flames such as gas hot water.