ESP Warning Light Comes ON Steady

ESP (R) Warning Light Comes ON Steady

Circuit Diagram










Circuit Description

Refer to "Circuit Description" under ESP Warning Light Does Not Come ON after Pressing Engine Switch to Change the Ignition Mode of Keyless Push Start System to "ON ESP (R) Warning Light Does Not Come ON after Pressing Engine Switch to Change the Ignition Mode of Keyless Push Start System to "ON".

Troubleshooting


1. ESP (R) control module connector check
Check for proper connection to ESP (R) control module connector.
Is it in good condition?
YES
Go to Step 2.
NO
Connect connector securely.
2. DTC Check for ESP (R)
Perform DTC Check DTC Check.
Is there any DTC(s)?
YES
Go to applicable DTC troubleshooting.
NO
Go to Step 3.
3. ESP (R) control module power supply and ground circuit check
Check ESP (R) control module power supply circuit and ground circuit. Component Tests and General Diagnostics
Are they in good condition?
YES
Substitute a known-good combination meter and recheck DTC. Service and Repair
If ESP (R) warning light remains ON, substitute a known-good ESP (R) control module and recheck DTC. ESP Hydraulic Unit / Control Module Assembly Removal and Installation
NO
Repair ESP (R) control module power supply and ground circuit.