Actuator Check

LIST OF OPERATION METHODS




By operating each of the A/C control switches as shown the diagram, it is possible to enter the diagnosis check mode.

ACTUATOR CHECK




a. After entering the DTC check mode (Sensor Check Mode) press the R/F switch.
b. As each damper, motor and relay automatically operate actuator check at 1 second intervals from step No.1 to No.10 continuously, check the temperature and air flow visually and by hand.




If the slower display is desired, press the DEF switch and change it to step operation. Each time the DEF switch is pressed, the display changes by 1 step.

HINT:
- Code are displayed in order from the smaller to the larger numbers.
- To end the check mode, press the OFF switch.