Neutral Safety Switch: Adjustments

U660F AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: ADJUSTMENT

ADJUSTMENT

1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Remove the control shaft lever.
HINT: See the steps from "Remove Cool Air Intake Duct Seal" through "Remove Park/Neutral Position Switch Assembly" Removal.





(b) Loosen the 2 bolts of the park/neutral position switch.





(c) Align the protrusions of the park/neutral position switch.

Text in Illustration









(d) Hold the park/neutral position switch in position and tighten the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48in-lbf)
NOTICE: After installing the park/neutral position switch, confirm that the 2 protrusions on the switch are aligned.

(e) Install the control shaft lever.
HINT: See the steps from "Install Park/Neutral Position Switch Assembly" through "Install Cool Air Intake Duct Seal" Installation.

(f) After the adjustment, perform the switch operation check Initial Inspection and Diagnostic Overview.