Component Tests and General Diagnostics

TIRE / WHEEL: TIRE AND WHEEL SYSTEM: INSPECTION

INSPECTION

1. INSPECT TIRES
(a) Check the tires for wear and proper inflation pressure.
Cold Tire Inflation Pressure:









(b) Using a dial indicator, check the runout of the tires.
Maximum tire runout:
1.4 mm (0.0551 in.)
2. ROTATE TIRES





(a) Rotate the tires as shown in the illustration.

Text in Illustration





3. INSPECT WHEEL BALANCE





(a) Check and adjust the off-the-car balance.
Maximum wheel imbalance after adjustment:
8.0 g (0.0176 lb)

NOTICE:
- Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
- Do not touch the sticking surface of the tape.
- Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.
Width (A):
25 mm (0.984 in.)
- Push the balance weight securely with your finger to adhere it to the position.
- Do not reuse the balance weight.
- Use the TOYOTA genuine sticking type balance weights.
HINT: The inner side balance weight should be installed by clipping it to the rim.

4. INSPECT FRONT AXLE HUB BEARING LOOSENESS
(a) Inspect the front axle hub bearing looseness Front Axle Hub.
5. INSPECT REAR AXLE HUB BEARING LOOSENESS (for 2WD)
(a) Inspect the rear axle hub bearing looseness Rear Axle Hub.
6. INSPECT REAR AXLE HUB BEARING LOOSENESS (for AWD)
(a) Inspect the rear axle hub bearing looseness Rear Axle Hub.
7. INSPECT FRONT AXLE HUB RUNOUT
(a) Inspect the front axle hub runout Front Axle Hub.
8. INSPECT REAR AXLE HUB RUNOUT (for 2WD)
(a) Inspect the rear axle hub runout Rear Axle Hub.
9. INSPECT REAR AXLE HUB RUNOUT (for AWD)
(a) Inspect the rear axle hub runout Rear Axle Hub.