Installation

U660F AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: INSTALLATION

INSTALLATION

1. INSTALL SHIFT LEVER ASSEMBLY
NOTICE: Check that the park/neutral position switch and the shift lever are in neutral.

(a) Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.

Test in Illustration

(b) Turn the lock nut of the transmission control cable counterclockwise. While holding the lock nut, push in the stopper.

Test in Illustration

NOTICE: The lock nut is fully seated against the shift lever retainer.

(d) Install the transmission control cable end to the shift lever assembly.

Test in Illustration

NOTICE:
- Check that the lock piece is pulled up.
- Install the cable end all the way to the base of the pin.

(e) Install the shift lever assembly with the 4 nuts.
Torque: 12 Nm (122 kgf-cm, 9ft-lbf)
(f) Connect the 2 connectors.

(g) Push the lock piece into the adjuster case.

Test in Illustration

NOTICE: Securely push in the lock piece until the slider lock is engaged.

2. INSTALL CONSOLE BOX SUB-ASSEMBLY Installation
3. INSTALL POSITION INDICATOR HOUSING ASSEMBLY Installation
4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation
5. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation
6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
8. INSTALL FRONT DOOR SCUFF PLATE RH Installation
9. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation
10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
11. INSTALL FRONT DOOR SCUFF PLATE LH Installation
12. INSTALL AIR CONDITIONING CONTROL ASSEMBLY Installation
13. INSTALL CONSOLE BOX ASSEMBLY Installation
14. INSTALL NO. 2 CONSOLE BOX CARPET Installation
15. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) Installation
16. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) Installation
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

18. INSPECT SHIFT LEVER POSITION Adjustments
19. ADJUST SHIFT LEVER POSITION Adjustments