Lighting System

LIGHTING (EXT): LIGHTING SYSTEM: B2432: Lost Communication with Automatic High Beam Sensor
B2432 - Lost Communication with Automatic High Beam Sensor

DESCRIPTION

The DTC is stored when the AFS ECU (headlight swivel ECU assembly) detects malfunctions in the LIN communication system.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK FOR DTC

(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(b) Check for DTCs Reading and Clearing Diagnostic Trouble Codes.

OK:

DTC B2432 is not output.

NG -- CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - HEADLIGHT ASSEMBLY)

OK -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting

2. CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - HEADLIGHT ASSEMBLY)

(a) Disconnect the D44 AFS ECU (headlight swivel ECU assembly) connector.

(b) Disconnect the P12 inner rear view mirror assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. INSPECT AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)

(a) Reconnect the D44 AFS ECU (headlight swivel ECU assembly) connector.

(b) Connect an oscilloscope to the P12 inner rear view mirror assembly connector.

OK:

Text in Illustration

NG -- REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) Components

OK -- REPLACE INNER REAR VIEW MIRROR ASSEMBLY Components