Drive Plate

Drive Plate

Special tools, testers and auxiliary items required

• Depth Gauge

Removing

- Remove the transmission.

- Lock the crankshaft, refer to => [ Crankshaft, Locking ] Procedures and remove the drive plate.

Installing

- Install the drive plate only by using a washer with recesses - 1 - (without compensating shim - 2 -).






- Install new bolts - 3 - and tighten them to 30 Nm.

- Check the dimension - a - at three points and calculate the mean value.






Specified value: 18.8 to 20.4 mm

• Measure through the drive plate hole to the surface of the control housing cover.

If the specification is not obtained:

- Remove the drive plate again and use the shim - 2 -. Tighten the bolts - 3 - to 30 Nm again and repeat the measurement.






If the specified value is OK:

- Tighten the bolts to 60 Nm + an additional + 90° (1/4) turn, the additional turn n may occur in several stages.

The rest of the installation follows the reverse of the removal procedures. When doing this note the following:

• Remove the locking pin (T40069) from the rear of the cylinder block and install the locking bolt.

Tightening Specifications