License Plate Lamp Attached By Screws

License Plate Lamp Attached by Screws

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

- Remove mounting bolts - 1 - from License Plate Lamp - 2 -.





- Using a suitable screwdriver, carefully pry License Plate Lamp out of bumper cover at recess - arrow -.

- Disengage and disconnect harness connector - arrow -.





- Pry diffusion lens - 1 - out of license plate light housing - 2 - in direction of arrow using a suitable screwdriver.





• When prying out the diffusion lenses, make sure that the gasket between diffusion lens and license plate light housing is not damaged.

License Plate Lamp: tubular bulb 12V, 5 W.

Installing:

Install in reverse order of removal, noting the following:

When assembling license plate light, make sure that diffusion lens gasket has proper fit.