Operation CHARM: Car repair manuals for everyone.

Headlamp Spray Nozzle Holder






Headlamp Spray Nozzle Holder


Turn off the ignition and all electrical consumers.

Remove the key.

Removal

- Remove the spray nozzle, with the cap - 1 -, from the bumper cover to the stop.






- Remove the cap - 1 - from the mountings - arrows - on the spray nozzle holder.

- Lift the retaining hook - arrow - slightly and remove the spray nozzle holder.






Installation

Use the spray nozzle bracket to adjust how far the cap on the nozzle is pulled into the bumper cover. The cap will not close if the spray nozzle bracket does not retract far enough. If the spray nozzle bracket moves with too much force, the cap and the bumper cover will get damaged.

- Slide spray nozzle holder into lift cylinder until it engages.

- Install cover cap onto the spray nozzle holder and let down lift cylinder.

- Check cover cap for correct seating on bumper cover.

- Adjust cover cap if necessary by shifting spray jet holder into a higher or lower catch on the lift cylinder.

- Bleed the headlamp washer systems. Refer to=> [ Headlamp Washer System, Bleeding ] Headlamp Washer System, Bleeding.