Drive Plate
Drive Plate
Special tools, testers and auxiliary items required
• Depth Gauge
Removing
- Remove the transmission.
- Lock the crankshaft, refer to => [ Crankshaft, Locking ] Procedures and remove the drive plate.
Installing
- Install the drive plate only by using a washer with recesses - 1 - (without compensating shim - 2 -).
- Install new bolts - 3 - and tighten them to 30 Nm.
- Check the dimension - a - at three points and calculate the mean value.
Specified value: 18.8 to 20.4 mm
• Measure through the drive plate hole to the surface of the control housing cover.
If the specification is not obtained:
- Remove the drive plate again and use the shim - 2 -. Tighten the bolts - 3 - to 30 Nm again and repeat the measurement.
If the specified value is OK:
- Tighten the bolts to 60 Nm + an additional + 90° (1/4) turn, the additional turn n may occur in several stages.
The rest of the installation follows the reverse of the removal procedures. When doing this note the following:
• Remove the locking pin (T40069) from the rear of the cylinder block and install the locking bolt.
Tightening Specifications