Drive Plate

Drive Plate

Special tools, testers and auxiliary items required

• Depth gauge

Removing

- Remove the transmission.

- Lock the crankshaft, refer to --> [ Crankshaft, Locking ] Crankshaft, Locking, and remove the drive plate.

Installing

- Install drive plate only by using a washer with recesses - 1 - (without compensating shim - 2 -).





- Install the new bolts - 3 - and tighten to 30 Nm.

- Check dimension - a - an three points and calculate the mean value.





Specified value: 18.8 to 20.4 mm

• Measure through the drive plate hole to the surface of the control housing cover.

If the specification is not obtained:

- Remove the drive plate again and use shim - 2 -. Tighten the bolts - 3 - to 30 Nm again and repeat the measurement.





If the specified value is OK:

- Tighten the bolts to 60 Nm and turn an additional + 90° (1/4 rotation, additional rotation may occur in several stages).

The rest of the installation follows the reverse of the removal procedures. When doing this note the following:

• Remove the (T40069) from the cylinder block and install the locking bolt. Tightening specification: 30 Nm.