Headlamp Washer Spray Nozzle Holder

Headlamp Washer Spray Nozzle Holder


Do not remove the spray nozzle lift cylinders by hand.

Depending on the design, a lift cylinder, which was manually removed, can jam up during the return stroke.

Do not manually push the lift cylinder back down; this will damage the lift cylinder.

A jammed lift cylinder will become functional again once it activated by the system.

Extend the lift cylinder only with water or air pressure.

Removing

- Turn off the ignition and all electric consumers and remove the key.






- Extend the lift cylinder by operating the headlamp washer system and holding it.

- Unclip the cover cap - 1 - from the locking mechanisms - arrows - on spray nozzle holder.

- Lift lug - arrow - slightly and pull out spray nozzle holder.






Installing

• Use the spray nozzle bracket to adjust how far the cap on the nozzle is pulled into the bumper cover. The cap will not close if the spray nozzle bracket does not retract far enough. If the spray nozzle bracket moves with too much force, the cap and the bumper cover will get damaged.

- Slide spray nozzle holder into lift cylinder until it engages.

- Remove the cap on the spray nozzle holder and lower the lift cylinder.

- Check cover cap for correct seating on bumper cover.

- Adjust the cap if necessary by shifting the spray nozzle holder into a higher or lower catch on the lift cylinder.

- Bleed headlamp washer system after completing assembly work. Refer to => [ Headlamp Washer System, Bleeding ] Procedures.

- Check the spray nozzles for the headlamp cleaning system and adjust if necessary. Refer to => [ Headlamp Washer System Spray Nozzles, Adjusting ] Headlamp Washer System Spray Nozzles, Adjusting.