Checking Resistance In Circuit to Valves [EM2]

Checking Resistance In Circuit To Valves





- Ignition off.





- Connect test box and check ground point as per JA. Connecting test box. Connecting Test Box [JA]

Disconnect combination relay 15- pin connector.

- Disconnect control module.

Connect an ohmmeter between combination relays 15-pin connector terminal 9 and #3 on test box.

Ohmmeter should read approx. 0 Ohms.

If reading is OK:
- Checking resistance to ground in circuit to valves EM6. Checking Resistance to Ground In Circuit to Valves [EM6]

If reading is incorrect:
- Checking hydraulic unit connector EM3. Checking Hydraulic Unit Connector [EM3]