WC. Adjusting the TP Switch

WC. Adjusting the throttle position (TP) switch

WC1




Adjusting the throttle position (TP) switch
Start by turning the TP switch clockwise as shown by the arrow (A) until it stops. Then turn the TP switch counter-clockwise as shown in the illustration by the arrow (B) until a "click" is heard, and then continue to turn until it stops, but no further. The throttle must not start to open, so hold it closed with a finger on the throttle disc. keeping the TP switch in the position, tighten the screws on the switch.

WC2




Checking
- Open the throttle and check the gap between the throttle lever and adjustment screw with a feeler gauge.
With a 0.45 mm feeler gauge there should be no click from the idle switch when the throttle is closed.
With a 0.15 mm feeler gauge there should be a click from the idle switch when the throttle is closed.
- Connect TP switch connector.
^ Continue with WD. Adjusting throttle mechanism. WD. Adjusting Throttle Mechanism