Air Cleaner Housing: Service and Repair

Replacing the air cleaner (ACL)

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Preparations
Remove the front engine cover if applicable.

Remove:
- the cable from the battery negative terminal. First read Note when disconnecting and connecting the battery lead Battery Disconnecting
- the cable from the battery positive terminal
- the battery.

Removing the air cleaner (ACL) housing





Remove:
- the connectors from the mass air flow (MAF) sensor and the assisted air control valve. Disconnect the connectors, vacuum hoses and wiring from the air cleaner (ACL) housing
- the assisted air control valve from the air cleaner (ACL) housing
- the inlet hose from the terminal on the mass air flow (MAF) sensor
- the preheating hose.





Remove:
- the screws for the relay box. Move the box to one side
- the screws for the air cleaner (ACL) housing.
Release the clip holding the fresh air intake on the air cleaner (ACL) housing. Lift off the air cleaner (ACL) housing assembly.

Installing the air cleaner (ACL) housing




Position the air cleaner (ACL) housing.

Install:
- the screws for the air cleaner (ACL) housing
- the screws for the relay box
- the preheating hose
- the inlet hose
- the assisted air control valve.
Reconnect the vacuum hoses, connectors and wiring.

Installing the battery

Install:
- the battery
- the cable on the battery positive terminal
- the cable on the battery negative terminal. First read Note when disconnecting and connecting the battery lead Battery Disconnecting.
Install the front engine cover if applicable.