Removal and Replacement

SRS control module

Preparations
Prepare the car according to Note when disconnecting and connecting the battery lead Battery Disconnecting

Removing the control module





Remove:
- the rear center console according to Rear center console Rear Center Console
- the three screws.
Press in the lock (1) on the connector.
Move the mounting bracket (2) from the lug.
Disconnect the connector (3).
Remove the control module.

Caution! Do not touch the pin on the connectors. Static discharge may damage the control module.

Installing the control module





Caution! Ensure that there is no dirt between the control module and the body bracket.

Connect the connector.
Lock the connector with the mounting bracket (2).
Install the sensor module using new screws. Tighten the screws. Tighten to 10 Nm.

Note! It is important that the sensor module is correctly installed on the chassis so that a collision can be registered.

Install the rear center console according to Rear center console Rear Center Console.

Finishing work
Prepare the car according to Note when disconnecting and connecting the battery lead Battery Disconnecting.
Check that the SRS indicator lamp goes out after approximately 10 seconds.