Rear

Rear Stabilizer Bar Link

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Note! If the vehicle is equipped with anti-roll bars where the links have rubber bushings, see: Rear Stabilizer Bar Link.

Removal





Remove:
- the 2 nuts. Counterhold the ball joint using a Torx wrench
- the link.

Installing the anti-roll bar link

Note! For tightening torques, see Specifications. [1][2]Specifications

Install:
- the new link
- the 2 M10 nuts.
Use a Torx wrench as a counterhold so that the boot is not damaged.