Rear Wheel Hub

Rear wheel hub

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Removing components





Remove:
- the wheel
- the 2 x screws
- the brake caliper. Hang up the caliper in a suitable position to avoid damaging the brake hose
- the brake disc. See: Rear brake disc Rear Brake Disc, Replacing.

Removal

Removing the wheel hub





Remove:
- the 1 screw (1)
- the ABS sensor
- the 4 x screws (2)
- the drive shaft center screw (3)
- the wheel hub
- the brake backing plate.

Installation

Installing the wheel hub

Note! For tightening torques, see Specifications. [1][2]Specifications





Install:
- the brake backing plate
- the wheel hub
- the 4 x M10 screws (2). Tighten. See: Tightening torque [1][2]Specifications
- the drive shaft center screw. Tighten. See: Tightening torque [1][2]Specifications
- the ABS sensor
- the M5 screw (1) for the ABS sensor. Tighten. See: Tightening torque [1][2]Specifications

Finishing

Installing components

Install:
- the brake disc. See: Rear brake disc Rear Brake Disc, Replacing
- the brake caliper
- the 2 screws for the caliper holder. Tighten. See: Tightening torque Tightening Torque
- the wheel. See: Wheels Service and Repair.