Seat Belt Front, Replacing
Seat belt front, replacing
As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.
Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected non-deployed seat belt tensioner. There is a risk that the seat belt tensioner could deploy.
Warning! The seat belt tensioner must never be taken apart, repaired or moved to another vehicle.
Preparations
Move the front seat as far forward as possible. Fold the backrest forward.
Disconnect the battery lead. See Battery, disconnecting Battery Disconnecting.
For information about handling seat belt tensioners, see Handling non-deployed SRS-components Discarding Pyrotechnic Components.
Removing front seat belts
Remove:
- the end mounting. See End mounting, replacing End Mounting, Replacing
- the B-post panel. See Panel B-post, replacing Panel B-Post, Replacing
- the connector
- the three screws
- the clip for the mounting for the SRS ignition cable in the bracket
- the bracket for the seat belt and seat belt (inertia) reel.
Installing front seat belts
Install:
- the bracket for the seat belt
- the 3 screws. Tighten. See
- the connector
- the B-post panel. See Panel B-post, replacing Panel B-Post, Replacing
- the end mounting. See End mounting, replacing End Mounting, Replacing
Check the function of the seat belt. See Seat belt function, check Testing and Inspection.
Carry out a final inspection. See Supplementary restraint system (SRS), inspection Testing and Inspection.