Drive Shaft Right, Replacing

Drive shaft right, replacing

Removal

Measure the position of the wheel spindle/spring strut. See: Wheel knuckle / spring strut, calibrating Service and Repair.

Leave the lower screw in place.

Applies from chassis no.: 1354476-

Use: 999 7251 Press tool 999 7251 Press Tool and 951 2923 Hydraulic hole cylinder 951 2923 Hydraulic Hole Cylinder.

Remove the drive shaft.

Note! Pull the constant velocity joint, not the drive shaft joints, when removing the drive shaft. There are no axial stops.

Note! Do not damage the drive shaft seal.

Installation

Note! For tightening torques, see: [1][2]Specifications

Lubricate the drive shaft sealing surface.
Use oil. See: Specifications

Use new screws and nuts.
Adjust the position of the wheel spindle/spring strut. See: Wheel knuckle / spring strut, calibrating Service and Repair.

Tighten, see: Tightening torque [1][2]Specifications.

Tighten, see: [1][2]Specifications