B220F

B220F-OCCUPANT RESTRAINT CONTROLLER CONTROL DRIVER 1

- When Monitored:
With the ignition on. The Occupant Restraint Controller (ORC) on board diagnostics continuously performs internal circuit tests.

- Set Condition:
This DTC will set if the ORC identifies an out of range internal circuit.





REPLACE THE ORC

NOTE: Make sure the battery is fully charged.

NOTE: When this DTC is set, the module self test has discovered an internal fault that cannot be repaired and the module must be replaced regardless of DTC status.

NOTE: When this code is set active or stored do not erase the codes.

Does the scan tool display B220F-OCCUPANT RESTRAINT CONTROLLER CONTROL DRIVER 1 DTC?

Yes

- WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

- WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

- Replace the Occupant Restraint Controller.
- Perform the ORC VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.

No

- No problem found at this time.