B2210

B2210-OCCUPANT RESTRAINT CONTROLLER CONTROL DRIVER 2

- When Monitored:
With the ignition on. The Occupant Restraint Controller (ORC) on board diagnostics continuously performs internal circuit tests.

- Set Condition:
This DTC will set if the ORC identifies an out of range internal circuit.





REPLACE THE ORC

NOTE: Make sure the battery is fully charged.

NOTE: When this DTC is set, the module self test has discovered an internal fault that cannot be repaired and the module must be replaced regardless of DTC status.

NOTE: When this code is set active or stored do not erase the codes.

1. With the scan tool, read the active and stored ORC DTC.

Does the scan tool display B2210-OCCUPANT RESTRAINT CONTROLLER CONTROL DRIVER 2 DTC?

Yes

- WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

- WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

- Replace the Occupant Restraint Controller.
- Perform the ORC VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.

No

- No problem found at this time.