Engine Control Module: Service and Repair

Powertrain Control Module (PCM) - 2.0L GTDI

Removal

1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to Information Bus.

2. Disconnect the 2 PCM electrical connectors.
- Detach the wiring harness retainer from the cowl.






3. Remove the 2 nuts and the PCM and bracket assembly.





4. Remove the 3 bolts and remove the PCM from the bracket.





Installation

1. Install the PCM to the bracket and install the 3 bolts.
- Tighten to 8 Nm (71 lb-in).






2. Install the PCM and bracket assembly and the 2 nuts.
- Tighten to 8 Nm (71 lb-in).






3. Connect the 2 PCM electrical connectors.
- Attach the wiring harness retainer to the cowl.






4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to Information Bus.

5. Reprogram the Passive Anti-Theft System (PATS). Carry out the Parameter Reset procedure. For additional information, refer to Antitheft and Alarm Systems. Passive Anti-Theft System (PATS)

6. After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.